Furman M-8S 120V/15A Power Sequencer 8 Switched Outlets in the Rear

Merit M-8S Power Sequencer is the perfect low-cost AC power solution for any rack mount system where power sequencing is desired.

Install an M-8s in to the top slot of your rack, and the six delayed outlets in the rear panel will power up sequentially and protect all your equipment up to a 15-amp load.

Includes 3 delayed outlet banks - each with 2 outlets - plus 2 unswitched outlets.

• Power Sequencing
  • Prevents excessive inrush currents.
  • Six sequenced rear panel outlets (in three groups), two unswitched rear panel outlets, and one front panel unswitched outlet.
  • Momentary and maintained sequencing via rear panel terminal block or front panel switch (momentary only).
• Noise Filtration
  • Noise filtering to reduce radio frequency and electromagnetic interference.
• Surge Protection
  • Ensures equipment stays safe.
• 9 Total Outlets
  • Eight rear panel outlets and one front panel convenience panel outlet.
• 15 Amp Rating
  • 15 amp rating, with circuit breaker.
• "Protection OK" Indicator
  • Front panel indicator LEDs for Outlet Banks, Protection OK and Power Status.
• Wall Wart Spacing
  • Rear outlets have been spaced to accommodate even the bulkiest of wall warts and adapters.
• All settings and configurations available on rear panel.

General

• FamilyMerit Series
• Line Voltage120 (Volts)
• BlueBOLT EnabledNo

AC Protection

• Automatic Voltage ShutoffNo

Shipping Info

• Length21.9 (Inches)
• Width9.4 (Inches)
• Height3.4 (Inches)
• Weight7.65 (Lbs)
• Unit of MeasureEach
• UPC654061041078
• Master Pack Qty6

Other Specifications

• Maximum AC Current Rating15 Amps, 120 VAC (Thermal breaker)
• AC Cord14AWGx3, 10 feet, black, fixed, NEMA 5-15P plug
• Convenience Outlet (Front Panel)1 Un-switched NEMA 15-5R
• Rear Panel Outlets2 Un-switched NEMA 5-15R (1 duplex)
• 6 Sequenced NEMA 5-15R (3 duplexes, each controlled by separate relay)
• AC Surge ProtectionMerit Class (sacrificial)
• Spike Protection ModeLine to neutral, zero ground leakage
• Max Continuous Operating Voltage130V RMS
• Max Clamp Voltage 500 Volts Peak
• Peak Impulse Current 12,000 Amps
• Energy Rating (2 X 820µS)225 Joules
• AC FilteringPi LCR Filter
• Noise Attenuation>26dB, 100 Khz to 1 MHz
• Operating Temperature Range5C (40F) to 40C (105F) degrees
• Humidity Range<90% rH (Relative Humidity)
• Rocker SwitchFront panel, Sequence (ON, OFF)
• Thermal Circuit BreakerFront panel, push to reset
• Front panel indicatorsDelay 1, Delay 2, Delay 3, Power, Protection OK
• Control/Status/Triggering (Rear Panel)Rear Panel DIP Switches: 12V Mode On/Off, GND Mode On, Momentary/Maintained
• PotentiometerRear panel, time calibration fine tune delay adjust
• Remote Terminal+5-30VDC In, 12VDC (12mA) Out
• Remote Terminal Phoenix type 4-Pin Connector with Screw terminals; +12V, STAT, REM, GND (Class 2 Wiring)
• Size1.75" X 19.00" X 6.5" (HWD) – ANSI 1RU
• Mass 5.3 lbs.
• Power Consumption (No Load) 5 Watts
• Safety Agency C/CSA/US